Sonar cable thru hull seal

images sonar cable thru hull seal

Send a private message to Corndog Attached Images. Get some BoatLife clear sealant and a clam shell for the outside. So, one big hole done properly can be a better option than a bunch of smaller holes You may not post new threads. Forum Jump. Category Sports. Find More Posts by onokai. Heres my take on it and my boat is similar. I didnt have any leaks.

  • Hole in Transom for Transducer The Hull Truth Boating and Fishing Forum
  • Sealing Hole for Transducer Cable The Hull Truth Boating and Fishing Forum
  • Sealing a hole for transducer wire Club Sea Ray

  • Marine Electronics Forum - Sealing Hole for Transducer Cable - Had posted a question in the Boating forum, it may have been better to post. Do-It-Yourself: Installing a Thru-Hull Transducer.

    Hole in Transom for Transducer The Hull Truth Boating and Fishing Forum

    will ensure there is marine sealant in the threads to seal the hull and hold the hull nut securely in place. From outside the hull, thread the cable through the mounting hole. : Boating Accessories NEW SEACHOICE CABLE THRU-HULL FITTING-BLACK SCP Home SEACHOICE 1 Inch White Water Tight Thru Hull Wire and Cable Pass Thru Fitting for Boats. Does not fit for a sonar cable.
    Thread Tools Show Printable Version.

    images sonar cable thru hull seal

    I would again recommend to wire tie it all back to be a clean installation and make sure it's not interferring with anything. Mar 25, 2. Thread Tools. Hobie 15, views. Last edited by Wetdline; at PM.

    Sealing Hole for Transducer Cable The Hull Truth Boating and Fishing Forum

    images sonar cable thru hull seal
    ADAM AND JOEL ROOSTER TEETH PRODUCTIONS
    Senior Member.

    Send a private message to thataway. I am going to install my transom mounted transducer for my Garmin s finally. Your thoughts? On test: JP54 - a featherweight 54ft fast cruiser like no other - Duration: I also over drilled the holes needed and filled with thickened epoxy then re drilled holes to the correct size.

    Find More Posts by AdrenalinJunkie.

    Any special instructions for drilling the hole in the transom and.

    I ran the wire, then put some duct tape inside the hull over the wire to make a.

    Sealing a hole for transducer wire Club Sea Ray

    A sea chest for housing and sealing the transducer should be designed and in alloy, plastic, or steel, provides the transducer cable through-hull seal. Thru-hull transducer or transom transducer or maybe an in-hull transducer? . Feed the transducer cable with plug through the hole and seal the hole with.
    I would definitely use one again.

    images sonar cable thru hull seal

    Find More Posts by scullym. Is this also a common location Below the water line? My boat restoration project - Duration: I like over the top no holes in hull.

    images sonar cable thru hull seal

    The reason is to let the raw wood absord the resin to waterproof it. Log in.

    images sonar cable thru hull seal
    4 STEP LADDER HOMEBASE IRELAND
    But that's just me When I bought my boat the transom was wet, I replaced it myself but the cause was the motor bracket had been raised 4" at some in time in the past.

    Video: Sonar cable thru hull seal How-To: Install Thru-hull Fittings in Boat Hull

    Send a private message to Following C. Austin Kayakviews. This feature is not available right now. Then once through the hole at the engine bay bulkhead, use some silicone to reseal the hole you may have to pull out the gob of sealant.

    1 Kомментарий